Hyundai H-LCD1502 - Manual (Page 9)

9
General operations
Turning ON/OFF
1. Plug the end of the power cord into an appropriate wall outlet and connect the antenna cable or
CATV cable.
2. Turn on the TV. Switch on the POWER button on the front panel of TV to connect AC power.
When the power of the TV is connected, the power indicator lights up in red, the TV is in
standby mode, press the POWER button on the RC or front panel to switch the set to normal
operation mode.
3. Turn off the TV. Press the POWER button on the RC or front panel to switch the set to standby
mode. Switch off the power switch on the front panel of TV to cut AC power.
Note: Unplug the set from the AC outlet when it is not to be used for a long period of time.
4. Select the TV channel or adjust the TV sound.
Press PROG+/- buttons on the RC to select memorized TV programs (press VOL+/- buttons to
adjust the volume).
Press PROGRAM UP/DOWN buttons on the front panel to select memorized TV programs (press
VOLUME UP/DOWN buttons to adjust the volume).
Press the number buttons to enter a program number directly, after a while, the set will turn to the
program automatically.
Button functions
P.P.
1. Press the P.P button on the RC to display the current picture state.
2. Press the P.P button repeatedly to select different picture effect.
3. The on-screen display will disappear in 3 seconds if you stop adjusting.
Note: You can select Standard, Bright, Personal or Soft.
SLEEP
1. Press the SLEEP button on the RC to display the sleep time.
2. Press the SLEEP button repeatedly to select a time period after which the TV will turn itself
off.
3. The on-screen display will disappear in 3 seconds if you stop adjusting.
Note: You can select 0 (off), 5, 10, 15, 20, 25, 30, 45, 60, 90, or 120 minutes. In the last minute of
the sleep time, the words “POWER OFF” will display at the top left corner of the screen. You can
press any button to cancel the setting at this time.
S.M
1. Press the S.M button on the RC to display the current sound state.
2. Press the S.M. button repeatedly to select different sound effect.
3. The on-screen display will disappear in 3 seconds if you stop adjusting.
Note: You can select News, Theater, Odeum, Personal.
AV/TV
1. Press the AV/TV button on the RC to display the signal source selection menu.
2. Press the PROGRAM UP/DOWN button to select your desired signal source.
3. Press the VOLUME UP button to confirm your selection.
4. The on-screen display will disappear in 15 seconds if you stop adjusting.
ZOOM (could be different base on different model)
1. Press the ZOOM button on the RC to display the current zoom mode.
2. Press the ZOOM button repeatedly to select your desired picture zoom effect.
3. The on-screen display will disappear in 3 seconds if you stop adjusting.
Note: You can select 16:9 or 4:3.