Radio Shack CD-3318 - Manual (Page 11)

11
3. Select the track you want by
pressing SKIP or . The
track number you selected
appears on the display.
Note: To select track 10 or a track
number greater than 10, press
+10 . The track number changes in
increments of ten.
4. Press PROGRAM . The selected
track is stored, and the next pro-
gram number appears on the dis-
play.
5. Repeat Steps 3 and 4 to store up
to 16 tracks.
Notes:
• You can store the same track
more than once.
• When the 16 tracks of the
sequence are programmed,
-01 and the first track’s num-
ber appear on the display.
6. To complete programming and
play the programmed sequence,
press
PLAY/PAUSE . The CD
player begins playing the first
track of the programmed
sequence. The display shows the
play indicator, the current track
number, and the current track’s
elapsed playing time.
Notes:
• Programming is not completed
until you press PLAY/PAUSE .
• To repeat, skip over, or search for
tracks, see “Special CD Player
Features.”
Checking a Programmed
Sequence
To check the programmed sequence,
while the CD is stopped, repeatedly
press
PROGRAM . The display shows
each stored track number.
Erasing a Programmed
Sequence
Any of the following will erase a pro-
grammed sequence:
• Press STOP/CLEAR until
clears from the display and the
CD’s total number of tracks and
playing time appear.
• Press STOP/CLEAR . Then
press PUSH OPEN after the CD
stops turning.
• Set RADIO.CD OFF to either TAPE
or RADIO .
• Disconnect the power source.
PROGRAM
14-542.fm Page 11 Wednesday, June 30, 1999 3:38 PM