Radio Shack ET-546 - Manual (Page 8)

8
8. Carefully place the handset in the
cradle at the top of the base and
make sure it is secure.
9. Move the base’s antenna to a ver-
tical position.
Note: If you later want to mount the
base on a desktop, press
PUSH on the
bottom of the base and slide the brack-
et down to remove it.
Mounting the Base Directly
on the Wall
You need two wood screws (not sup-
plied) for this mounting method.
1. Drill two holes 3 15 /
16
inches apart.
Then thread a screw into each
hole, letting the heads extend
1 /
4
inch from the wall.
2. Plug one end of the supplied mod-
ular cord into the TEL. LINE jack
on the back of the base.
3. On the bottom of the base, route
the modular cord downward and
under the slot’s clips as shown.
4. Attach the bracket to the bottom of
the base by inserting the tabs on
the bracket into the slots on the
base, then sliding the bracket up.
5. Insert the supplied AC adapter’s
barrel plug into the 12VDC jack on
the back of the base. Then plug
the adapter into a standard AC
outlet.
43-1046.fm Page 8 Tuesday, August 17, 1999 11:05 AM