Renesas R8C/Tiny Series - Manual (Page 12)

6.4. Serial port
This RSK provides two serial ports to the user. The serial port 1 has already been configured for use. To use serial port 2 the user needs to
configure the option links as given in Table 6-3.
Description Fit for RS232
TxD2 R34
RxD2 R33
Table 6-3: Serial Port settings
6.5. LCD Module
A LCD module is supplied to be connected to the connector ‘LCD’. This should be fitted so that the LCD module lies over ‘JA1’ and ‘JA5’.
Care should be taken to ensure the pins are inserted correctly into ‘LCD’ connector. The LCD module uses a 4 bit interface to reduce the
pin allocation. No contrast control is provided; this is set by a resistor on the supplied display module. The module supplied with the
Renesas Starter Kit only supports 5V operation.
Table 6-4 shows the pin allocation and signal names used on this connector.
J8
Pin Circuit Net Name Device
Pin
Pin Circuit Net Name Device
Pin
1 Ground - 2 5V Only -
3 No Connection - 4 DLCDRS 38
5 R/W (Wired to Write only) - 6 DLCDE 37
7 No Connection - 8 No Connection -
9 No Connection - 10 No Connection -
11 DLCD4 42 12 DLCD5 41
13 DLCD6 40 14 DLCD7 39
Table 6-4: LCD Module Connections
8