Rosewill RC216 User Manual

Page 11

User Manual

SATA II / ATA 133 PCIe Card RC216

For Windows® Vista 32 bit
For New Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy
the contents of the “

RC-216\Floppy32” folder, found on the driver CD, onto a blank floppy disk

then follow the directions below.
1. Setup the RAID Array prior to Windows installation.
2. Follow Microsoft’s Windows installation procedure.
3. Restart the computer when prompted by Windows’ installation.
4. At the Windows Setup screen, press

Load Driver to install the driver.

5. Insert the floppy disk, please select

JMicron JMB36X Controller (A:\jraid_f.inf), then press

Next. (Change A:\ to match your floppy drive letter)

6. Follow the on-screen instructions to complete the Windows installation.

For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up to Windows.
2. At the

Found New Hardware Wizard window pop-up, please click Cancel button to cancel

the driver installation for the device at this moment. The driver for this device will be installed in
the next step.
3. Please insert the CD driver bound with PCIe SATA II 300 + PATA Raid Card into your CD-ROM
Drive.
4. At the Windows desktop, click

Start, then Run.

5. Type

D:\ RC-216\Setup.exe, click OK. (Change D:\ to match your CD-ROM drive letter)

6. Follow the on-screen instructions to complete the installation.
7. Restart Windows to complete the installation.

For Windows® Vista 64 bit
For New Installation
A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy
the contents of the “

RC-216\Floppy64” folder, found on the driver CD, onto a blank floppy disk

Load Driver to install the driver.

5. Insert the floppy disk, please select

JMicron JMB36X Controller (A:\jraid_f.inf), then press

Next. (Change A:\ to match your floppy drive letter)

6. Follow the on-screen instructions to complete the Windows installation.