Adjusting the lens height (y), Adjusting the pitch (angle), Pre l iminar y – Runco Vision 85 User Manual
Page 45
Vidikron Vision 85 Owner’s Operating Manual
33
PRE
L
IMINAR
Y
Adjusting the Lens Height (Y):
1.
Project a white field on the screen.
2.
Ensure that the four Height (Y) Adjustment Screws are loose enough to allow vertical
movement of the lens assembly.
3.
Slowly move the anamorphic lens into place so that there are no shadows on the top or
bottom of the screen:
4.
When the height is properly set, tighten the Height Adjustment Screws to secure the
lens in place.
Adjusting the Pitch (Angle): Next, angle the lens to even out any top-to-bottom pincushion
distortion. To do this, loosen the Pitch Adjustment Screws on either side of the lens to allow it
to pivot freely. Then, adjust the anamorphic lens angle so that the projected image is
rectangular:
To avoid clipping the corners of the image, position the anamorphic lens
as close as possible to the primary lens.
Tip
Too High
Too Low
Correct position