Safety precautions, Operating the tool, Always hold tool perpendicular to work surface – Remington r300 User Manual
Page 8
8
119586
7. DO nOt drive power fasteners into steel base material
less then 3/16" thick, within " of a weld, within 1/" of the
edge, or within 1" of another power fastener.
3"
3"
3"
6. DO nOt drive power fasteners into concrete less than three
times as thick as the intended power fastener penetration,
within 3" of the edge, within 3" of another power fastener,
or within 3" of a failed power fastener.
8. When fastening into masonry walls, always drive into
horizontal mortar joints,
nEVEr into vertical mortar joints.
BE CarEFUL, a poorly laid joint may permit too much
penetration and/or unsatisfactory holding power.
OpEratInG tHE tOOL
1. aLWaYS hold tool perpendicular to work surface.
3"
3X
1X
3/16" mIn
1/2"
1"
YES
S
F
90˚
S
F
Safety precautions
tOO tHIn
WELD
NO
S
F