Remington r300 - Manual (Page 21)

1 119586
ImpOrtant
• Recommended for use with Remington
® power loads and
power fasteners.
• If power fastener goes below the top surface of the board,
use penetrating control disc (see illustration below) or wash-
ered SPW-type power fasteners.
• Operators and bystanders must aLWaYS wear goggles and
ear protection which meet or exceed the accepted standards
for adequate protection in your country. In the USA, refer to
ANSI standards. In Canada, refer to CSA standards.
* Use power fastener with penetration control disc, part
number 015549.
Power load listings are recommendations only. If you are in
doubt, try a test fastening using the next lightest power load.
Power fasteners and power loads are available in blister packs
of 5 and cartons of 100.
application Chart
Load Color Code
Stock Level Load Case
number number Strength Body Head
AC1 1 light brass Gray
AC medium brass Brown
AC3 3 heavy brass Green
AC4 4 extra heavy brass Yellow
. CALIBER Type A, neck-down crimp loads for powder
actuated tools
ImpOrtant
This tool is designed to use . caliber neck-down crimped
loads, power levels 1 (gray) through 4 (yellow).
5/8"
Straight Wadded
Power Load
Neck-Down Crimped
Power Load
CaUtIOn: Do not use any load other
than the .22 caliber neck-down crimped load.
Other types of loads will cause load-ejection
problems.