RedMax EXZ2401S-PH - Manual (Page 58)

58
8. Operation (PS-EX only)
English
Adjust the pump as follows:
1. Stop the engine and make sure the stop switch is in
the OFF position.
2. Place the unit on its side with the oil reservoir up.
(OP2)
(1) Oil tank
(2) Chain cover
The oil flow adjusting screw must be pressed in slightly
in order to turn. Failure to do so could damage the
pump and screw.
3. With a screwdriver, push in on the oil flow rate
adjusting screw and turn in the desired direction
(there are three incremental settings):
(a) Clockwise-decrease lubrication.
(b) Counter clockwise-increase lubrication.
(c) Middle
• Always wear work gloves made of leather or
some other sturdy material when using the
polesaw.
• Falling branches may fall onto the face or into
the eyes, resulting in injuries, scratches, and
cuts, and for this reason you should always be
sure to wear a helmet and face protector when
using your polesaw.
WARNING
IMPORTANT
PS-EX
OP2