Radio Shack TAD-704 - Manual (Page 8)

8
2. Repeatedly press REPEAT to select
the desired display contrast set-
tings.
Note: The TAD-704 provides ten
(
0 – 9 ) display contrast settings.
3. Press CALLBACK to lock in the set-
ting.
4. Press STOP to return to the time dis-
play.
SETTING THE LONG
DISTANCE CODE
Note: If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again at Step 1.
1. Hold down STOP until the TAD
beeps once.
2. Press CALLBACK once. 1 and SET
LDS CODE appear. 1 flashes.
3. Repeatedly press REPEAT to set the
long distance code to 1 , 9 , or 0 .
4. Press CALLBACK then press STOP
to return to the time display.
SETTING THE AREA
CODE
Note: If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again at Step 1.
1. Hold down STOP until the TAD
beeps once.
2. Press CALLBACK twice. 000 and
SET AREA CODE appear. The first 0
flashes.
3. Repeatedly press REPEAT until the
first digit of your area code appears,
then press
SKIP to the second digit.
The second 0 flashes.
Note: If you make a mistake,
repeatedly press
SKIP until the
desired digit flashes then re-enter
the code.
4. Repeat Step 3 to set the second and
third digits of your area code.
5. Press CALLBACK then press STOP
to return to the time display.
SETTING THE DAY, TIME
AND DATE
To avoid losing the day and time set-
tings if AC power fails, we recommend
you install a backup battery before you
set the day and time (see “Installing a
Backup Battery” on Page 7).
Follow these steps so the TAD can
record the correct day and time each
message and memo is recorded.
Note: If you do not complete each step
within 8 seconds, the TAD exits setup.
Start again at Step 1.
1. Hold down STOP until the TAD
beeps once.
2. Repeatedly press CALLBACK until
SUNDAY appears.
43-704.fm Page 8 Wednesday, November 17, 1999 4:47 PM