Radio Shack TAD-704 - Manual (Page 15)

15
1. Hold down STOP until the TAD
beeps once.
2. Press CALLBACK three times. 704
and SECURITY CODE appear. 7
flashes.
3. Repeatedly press REPEAT to set the
first digit, then press SKIP . The sec-
ond digit flashes.
4. Repeat Step 3 to set the second and
the third digits.
5. Press CALLBACK then press STOP
to return to the time display.
REMOTE OPERATION
You can operate the TAD from almost
any touch-tone phone, or from a rotary
phone using a pocket tone-dialer (avail-
able at your local RadioShack store).
USING REMOTE
COMMANDS
Follow these steps to operate the TAD
remotely.
1. Dial your phone number.
2. When the TAD answers, enter your
remote operation security code. The
TAD beeps once to confirm that you
entered the correct code.
Notes:
• If you do not enter each digit
within 8 seconds, the TAD hangs
up.
• If the TAD is not set to answer
calls, it answers after about 9
rings.
3. Enter a remote command.
4. When you finish, simply hang up.
USING THE TOLL-SAVER
If the ring select switch is set to TS (toll-
saver), the TAD-704 answers after two
rings if you have new messages. If there
are no new messages, the TAD answers
after four rings. This gives you time to
hang up before the TAD answers so you
can avoid unnecessary long-distance
charges. See “Setting the Number of
Rings” on Page 9.
43-704.fm Page 15 Wednesday, November 17, 1999 4:47 PM