Radio Shack TAD-704 - Manual (Page 23)

23
USING CALLBACK
You must store your home area code for
Callback to work correctly (see “Setting
the Area Code” on Page 8). If the call
came from your home area code, the
display shows only the seven-digit num-
ber (without an area code). Follow these
steps to dial a phone number from Call-
er ID records.
1. Repeatedly press REVIEW or
to select the desired phone number.
Then repeatedly press
VIP to select
the suitable dialing pattern for that
phone number.
2. Press CALLBACK to automatically
dial it. WAITING.. and DIAL-
ING.. appear, then the phone
number appears. Then, after the
TAD-704 dials the number,
PICK
UP PHONE 8 appears, and the TAD-
704 starts to count down from 8 to 1
on the display.
3. Pick up the phone within 8 seconds
before PICK UP PHONE 1 disap-
pears. If you do not pick up the
phone within 8 seconds, the TAD-
704 does not complete the call.
Repeat from Step 1 again to redial
the number.
Note: If you did not store an area
code while pressing
CALLBACK ,
SET AREA CODE appears for a few
seconds. See “Setting the Area
Code” on Page 8.
Calling the Last Dialed Number
To quickly call the phone number in the
last call record you dialed, simply press
CALLBACK at the time and date display.
WAITING.. and DIALING.. appear
(while it dials the number) then PICK
UP PHONE 8 appears. To complete the
call, pick up the phone within 8 seconds
before
PICK UP PHONE 1 disappears.
43-704.fm Page 23 Wednesday, November 17, 1999 4:47 PM