RIDGID WD55000 - Manual (Page 10)

10
Hanging Vac on Storage Rack
5. Lower the vac until the upper hook and
lower hook are engaged and the bottom
of the vac canister rests on the rack. The
release tab will pop out over the flange
on the motor assembly.
6. Snap the power cord into the cord
retainer in the front surface of the rack.
The cord may exit on either the left or
right side. Plug the power cord into the
electrical outlet. Do not fasten power
cord to wall in any way.
1. Set the vac on the floor near the storage
rack. Measure the distance from center
of storage rack to the closest electrical
outlet and add 18 inches.
2. Uncoil that amount of power cord from
the cord wrap. Drape the loose cord
over the top of the vacuum and down
the front.
Outlet
Distance
+
18 Inches
3. Grasp the handle with one hand and the
bottom of the vac canister at the front
with the other hand. Always lift the vac
with both hands. Lift the vac up to the
storage rack.
4. Align the upper hook on the vac with the
rectangular opening in the storage rack.
Push the vac against the storage rack.
Rectangular
Opening
Handle
Upper
Hook
Lower Hook
Release Tab
Storage Rack
Rectangular
Opening in
Storage Rack
Upper
Hook
Push
Vac
Against
Storage
Rack
Storage
Rack
Release
Tab
Upper
Hook
Lower
Hook
SP6625 5 gallon RIDGID 9/16/05 2:25 PM Page 10