Radio Shack PRO-76 - Manual (Page 11)

11
Warning: Never use the
CHARGE jack when you have
installed non-rechargeable
batteries. If you try to re-
charge non-rechargeable
batteries, they become very
hot and could explode.
Remove the plastic plug
from the
CHARGE jack before
you use it, then replace the
plug when you finish.
USING AC POWER
You can power the scanner
using a 9V, 300-mA AC
adapter and a size H
Adaptaplug
® adapter (nei-
ther supplied). Both are
available at your local Ra-
dioShack store.
Cautions:
You must use a
Class 2 power
source that
supplies 9V DC and de-
livers at least 300 mA.
Its center tip must be set
to positive and its plug
must fit the scanner's
POWER jack. Using an
adapter that does not
meet these specifica-
tions could damage the
scanner or the adapter.
• Always connect the AC
adapter to the scanner
before you connect it to
AC power. When you
finish, disconnect the
adapter from AC power
before you disconnect it
from the scanner.
To power the scanner using
an AC adapter, attach the
Adaptaplug adapter to the
AC adapter so the tip reads
positive (+), then insert the
Adaptaplug adapter into the
scanner’s
POWER jack.
Then connect the other end
of the adapter to a standard
AC outlet.
CHARGE
POWER
!
20-313.fm Page 11 Friday, January 7, 2000 3:09 PM