Radio Shack Speaker - Manual (Page 7)

7
Operation
Listening Safety
To protect your hearing, follow these
guidelines when you use the speaker system.
• Set the volume to the lowest setting
before you begin listening. After you
begin listening, adjust the volume to a
comfortable level.
• Do not listen at extremely high volume
levels. Extended high-volume listening
can lead to permanent hearing loss.
• Once you set the volume, do not
increase it. Over time, your ears adapt
to the volume level, so a volume level
that does not cause discomfort might
still damage your hearing.
Using Your Speakers
Follow these steps to obtain maximum
listening performance:
1. Turn on your audio source.
See Transmitter AUTO ON/OFF below
for the transmitter operation.
2. Set the transmitter to a frequency
channel ( CHANNEL 1 , 2 , or 3 ) that has
no interference.
Slide CHANNEL 1 2 3 at the rear of the
speakers to select the same channel
selected on the transmitter.
3. Turn on each speaker (Left and Right
speakers) by rotating POWER from
OFF to ON . You hear a click and the
power indicator lights green.
4. Set SPEAKER on the back of each
speaker to either L (for the Left stereo
speaker) or R (for the Right stereo
speaker).
5. Adjust VOLUME and BASS on each
speaker between MIN (minimum) to
MAX (maximum) to a comfortable
listening level.
6. To turn off each speaker, rotate POWER
from ON to OFF . The power indicator
turns off.
Transmitter AUTO ON/OFF
The transmitter has a built-in automatic
transmit ON/OFF controller. When the AC
adapter is correctly plugged in and the
transmitter receives audio signals from the
audio source, the transmitter’s power LED
lights green. The transmission stops if the
transmitter does not receive audio signals
from the audio source for about one minute.
The transmitter’s power LED turns off when
the transmitter does not receive audio
signals.
Channel Select
If you receive interference, try changing the
channel number on the transmitter and the
speakers.