Regency H15 - Manual (Page 14)

* The H15 can be vented horizontally with the AstroCap™ system. For rear vent applica-
tions, H25 requires a riser vent; H35 requires a riser vent and BTU reduction kit.
** H35 requires minimum 1ft. rise.
H15/H25/H35* H15/H25/H35** H15/H25/H35
D
D
A
A
B
A A
C
Left Side W
all
Right Side W
all
Left Side W
all
Right Side W
all
Clearances To Combustibles H15 H25 H35
A Side Wall To Unit 6" 6" 6-1/2"
B Back Wall To Unit 0" 3" 6"
C Vertical Vent to Back Wall 2" 2" 2"
D Side Wall To Unit (Corner) 2" 2" 2"
Minimum clearance of vent terminal to outside corner and inside corner: AstroCap™ 6", Dura-Vent Cap 12"
Dimensions H15 H25 H35
A 20-11/16" 22-5/8" 27"
B 22-1/2" 27" 28"
C 14-1/4" 14-1/4" 19-3/4"
D 16-3/16" 16-7/16" 21"
Shipping Weight 182 lbs. 196 lbs. 308 lbs.
A
B
C
D
A
B
C
D
Hampton® Gas Products
Specifications
H15 H25 H35
NG LP NG LP NG LP
Maximum BTU 18,000 18,000 25,000 23,000 36,000 34,000
Turn down to (BTU) 10,500 10,600 12,500 11,500 18,000 17,500
EnerGuide rating (Canada only) 62.31% 62.31% 61.15% 61.63% 68.34% 69.72%
Efficiency 80% 82% 83% 85% 83% 85%
Herringbone - Rustic Brown Standard - Rustic Brown Standard - Old Town Red
FireGenie® Remote Control
Turn your Hampton on and off from the comfort of your
sofa with the easy-to-use FireGenie.
Programmable Thermostat
Set a specific temperature with a Hampton wall thermo-
stat and maintain a constant comfort level in your home.
Brick Panels
Add one of three fully textured brick panels.
Note: Herringbone is not available for the H35.
gas stoves
accessories
NOTE: PRODUCT SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. BEFORE INSTALLING REFER TO THE RELEVANT PRODUCT MANUAL FOR FULL AND UP
TO DATE INFORMATION.
H15: Tested to the following standards:ANSIZ21.88-2003/CSA33-2002, CGA 2-17-M91
H25: Tested to the following standards: Gas-Fired Appliances For Use At High Altitudes CGA 2-17-M91, Vented Gas Fireplace Heaters ANS Z21.88a-2000/CSA 2.33a-2000.
Certified for Canada and the US.
H35: Tested to the following standards: CGA 2-17-M91, ANSIZ21.88b-1999/CSA 2.33b-M99. Certified for Canada and the US.
H15, H25 and H35 are approved for bedroom, alcove and mobile home installations.
All products tested to the following standards: GRAVITY DIRECT VENT WALL FURNACE TESTED AND APPROVED FOR U.S.A. AND CANADA TO: CAN/CGA-2.17-M91, ANSI
Z21.88b-1999/CSA 2.33b-M99.
14