Radio Shack ET-1124 - Manual (Page 13)

13
To delete a stored number, lift the
handset and press
MEM twice, then
enter the memory location number
(
0 – 9 ) you want to clear. The handset
sounds a long beep to signal that
the memory location is clear.
Entering a Pause
In some telephone systems, you must
dial an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. You can
store the access code with the phone
number. However, you should also store
a pause after the access code to allow
the outside line time to connect. To en-
ter a 2-second pause, press
PAUSE . For
a longer pause, press PAUSE additional
times.
Dialing a Memory Number
To dial a number stored in a standard
memory location, press
TALK . When you
hear a dial tone, press MEM and enter
the memory location number for the
number you want to dial.
Note: If you select an invalid or empty
memory location, the phone sounds an
error tone. Press
MEM and enter the
memory location number again.
Chain-Dialing Service Numbers
For quick recall of numbers for special
services (such as alternate long dis-
tance or bank-by-phone), store each
group of numbers in its own memory lo-
cation.
Dial the service’s main number first.
Then, at the appropriate place in the
call, press
MEM and enter the memory
location number ( 0 – 9 ) for the stored in-
formation.
Testing Stored Emergency
Numbers
If you store an emergency service’s
number (police department, fire depart-
ment, ambulance) and you choose to
test the stored number, make the test
call during the late evening or early
morning hours to avoid peak demand
periods. Also, remain on the line to ex-
plain the reason for your call.
USING A HEADSET
You can talk with hands-free conve-
nience using an optional headset that
has a
3 /
32
-inch (2.5-mm) plug. Contact
your local RadioShack store for a suit-
able headset.
To connect the headset, open the rub-
ber cover marked
on the side of the
handset, then insert the headset’s plug
into the jack.