Radio Shack ET-1124 - Manual (Page 10)

10
OPERATION
MAKING AND RECEIVING
CALLS
To make a call, lift the handset and
press
TALK . The TALK/BATT indicator
on the handset and the CHARGE/IN
USE indicator on the base light. When
you hear a dial tone, dial the number.
To answer a call, simply lift the handset.
If the handset is away from the base,
press any key.
To end a call, place the handset on the
base or press
TALK .
Note: If you press TALK to hang up and
the phone does not disconnect, press
TALK again while holding the handset
closer to the base, or place the handset
on the base.
SELECTING THE
CHANNEL
The phone scans 10 channels and auto-
matically selects a clear channel each
time you make or receive a call.
If you hear other conversation or exces-
sive noise during a call, press
CH to se-
lect a different channel. The TALK/BATT
indicator blinks, followed by a brief
pause as your phone searches for a
clear channel.
Note: If the handset is too far from the
base, the channel might not be clear.
Move closer to the base and try making
the call again.
SETTING THE HANDSET
VOLUME
You can choose one of four volume set-
tings (low, medium, high, or maximum)
for the handset. To change the volume,
press
VOL ▲ or ▼ during a call.
Note: When you press VOL ▲ while the
volume is maximum or VOL ▼ while the
volume is low, the setting does not
change and the phone sounds an error
tone.
USING REDIAL
You can quickly dial the last number di-
aled. When you hear a dial tone, simply
press
REDIAL .
TALK
REDIAL