ResMed Positive Airway Pressure Device VPAP IV ST - Manual (Page 6)

3 Using the VPAP IV and VPAP IV ST
En
gli
sh
Using the VPAP IV and VPAP IV ST
Setting up your VPAP
1
Connect the power cord to the socket at the rear of your VPAP.
2
Plug the other end of the power cord into the power outlet.
3
Connect one end of the air tubing firmly onto the air outlet.
4
Connect the assembled mask system to the free end of air tubing.
For information on assembling your mask, see your mask manual.
!
WARNING
• Make sure the power cord and plug are in good condition and the
equipment is not damaged.
• Only ResMed air tubing and accessories should be used with the device. Do
not use electrically conductive or antistatic hoses. A different type of air
tubing or accessory may alter the pressure the patient receives, reducing the
effectiveness of the treatment.
• Blocking the hose and/or air inlet of the device while in operation could lead
to overheating of the device.
!
CAUTION
• Be careful not to place the device where it can be bumped or where
someone is likely to trip over the power cord.
• If you put the device on the floor, make sure the area is free from dust and
clear of bedding, clothes or other objects that could block the air inlet.
1
2
3
4