RCA Satellite TV System - Manual (Page 11)

Chapter 1 9
Connections & Setup
What you will need:
• Two (2) RF coaxial cables
• One (1) S-Video cable
• Two (2) Audio/Video cables
• One (1) telephone line cord
• Coaxial cable lines fed from a digital satellite antenna and a standard TV antenna (or cable feed)
Making the Connection
1. Connect the satellite dish antenna feed (RG-6 coaxial cable) to the SATELLITE IN jack on the satellite
receiver.
2. Connect one end of an RF coaxial cable to the OUT TO TV jack on the satellite receiver, and the
other end to the antenna input jack on the VCR.
3. Connect one end of an RF coaxial cable to the antenna output jack on the VCR, and the other end to
the TV’s antenna input jack.
4. Connect the cable or off-air antenna feed (RF coaxial cable) to the IN FROM ANT jack on the satellite
receiver.
5. Connect one end of the supplied telephone line cord to the PHONE JACK on the back of the satellite
receiver, and the other end to an RJ11-type modular phone jack (the most common type of phone
jack).
6. Connect two ends of the supplied A/V cables to the AUDIO R and L jacks on the satellite receiver,
and the other ends to the corresponding audio input jacks on the TV.
Note: Make sure you connect jacks by their labels. For example, AUDIO R on the digital satellite
receiver should be connected to TV’s right audio input jack, L Audio to L Audio, etc.
If your TV only has one audio input jack, use the satellite receiver’s AUDIO L jack to make the
connection.
7. Connect one end of the supplied S-Video cable to the satellite receiver, and the other end to the
S-Video input jack on the TV.
Go to Page 16
Using Your Components
To watch DIRECTV ® programming:
Tune the TV to its S-Video line input (if you have difficulty finding your TV’s S-Video line input, see
your TV’s User’s Manual, or see page 64 in this manual). When the line input “channel” is found,
then you can tune the satellite receiver to a desired channel.
To record DIRECTV ® programming:
Follow the directions in the previous step, then set your VCR to record on its proper input channel
(channel 3 or 4).
To view VCR recordings:
Tune the TV to channel 3 or 4 (whichever is set on the VCR as its output channel). Begin VCR
playback as usual.