RedMax CHT2200 - Manual (Page 15)

■ STARTING ENGINE
• Keep the blades clear of the
surrounding as they will start moving
upon starting of the engine.
1. When first starting up after putting fuel into
the machine, push the priming pump until
fuel runs out in the clear tube. Then close
the choke. Choking may not be necessary
when re-starting right after stopping the
engine.
2. Pull the throttle lever and push the lock
button to set the lever in the START
position.
3. Slide the ignition switch to the engine side
to set it in the ON position.
WARNING
Operation
4. Rest the unit on a firm place. Pull the
starter knob quickly.
• Avoid pulling the rope to its end or returning
it by releasing the knob. Such actions can
cause starter failures.
5. When the engine has started, gradually
open the choke.
6. A l l o w the engine to warm up for a half
minute before starting operation.
• If the engine won't start after several
attempts, open the choke and repeat
pulling the rope or remove the spark plug
and dry it.
NOTE
NOTE
15 