Reebok Fitness 8100 ES RBTL79607.0 - Manual (Page 9)

9
8. Slide the Left Base Leg Cover (82) over the end of
the Left Upright (111). Attach the Left Base Leg
Cover with three #8 x 3/4" Screws (6) and two #8
x 2 1/4" Screws (7).
Be careful not to over-
tighten the Screws.
With the help of a second person, carefully tip
the treadmill down so that the Base (85) is flat on
the floor.
6
111
82
85
8
9. With the help of a second person, hold the con-
sole assembly near the Left Upright (111) and the
Right Upright (113)
.
Connect the Upright Wire Harness (73) to the
Console Wire (119).
See the inset drawing.
The connectors should slide together easily
and snap into place. If the connectors do not
slide together easily and snap into place, turn
one connector and try again.
IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN
YOU TURN ON THE POWER. Insert the con-
nectors and excess wire into the Right Upright
(113).
Insert the front ends of the brackets on the con-
sole assembly into the Right Upright (113) and
the Left Upright (111). Then, insert the rest of the
brackets into the Uprights.
Make sure that the
Wire Harnesses (73, 119) are not pinched.
73
113
111
Console
Assembly
9
7
73
Front of Bracket
119
119