Roberts Radio DreamTime2 - Manual (Page 6)

5
Operating your clock radio
1. Press the On / Standby button to switch on your clock radio.
When fi rst switched on, the radio will be in DAB mode. After each use
the radio will remember the mode used and then switch on in that
mode the next time that it is used.
2. If the clock radio has been used before, the last used station will be
selected.
3. If this is the fi rst time that the clock radio has been used a quick scan
of the Band III DAB channels will be carried out. During the scanning
process the display will show the progress of the station search. The
number on the right of the display is the number of stations that have
been found.
4. When the scan is completed the fi rst station (in numeric-alpha order
0...9, A...Z will be selected. The fi rst station in the list of stations found
during scanning will be played. The display will show the station name.
5. If no signals are found then 'OFF AIR' will be displayed and it may
be necessary to relocate your clock radio to a position giving better
reception. You should then carry out a scan to fi nd stations as described
on page 9.
• Your clock radio has an indicator on the display to indicate the
strength of the DAB radio signal being received.
Note: When fi rst switched on, the radio will set the volume to a moderately
high level, in case the broadcast is very quiet. After you have set the volume
using the Volume Up or Down buttons, the radio will remember the setting
that you have applied for the next time that it is used.
1