Roberts Radio DreamTime2 - Manual (Page 14)

13
Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your clock radio.
Place the wire antenna so that it is as straight as possible extending
either above or below the clock radio.
2. Press the On / Standby button to switch on your clock radio.
3. Press and release the Mode button until the FM band is selected.
4. Press the Tuning Up or Down buttons to tune to a station. The
frequency will change in steps of 50kHz.
If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Set the Volume to the desired setting.
7. To switch off your clock radio press the On / Standby button.
2,7
3
4
4
6 6