Operation – RIDGID R3120 User Manual
Page 16
OPERATION
Dustless Feature
See Figure 16.
For dustless operation, a vacuum attachment has been
provided with the saw. It attaches to the saw base.
WARNING:
The jig saw should never be connected to a power
supply when you are assembling parts, making
adjustments, cleaning, performing maintenance, or
when the tool is not in use. Disconnecting the tool
will prevent accidental starting that could cause
serious injury.
To Install:
Unplug the saw.
Slide the vacuum attachment into the curved area at
the rear of the base.
To Remove:
Unplug the saw.
Remove the vacuum attachment by pulling attachment
from base.
VACUUM ATTACHMENT
Fig. 16
16
See also other documents in the category RIDGID Power saws:
- R843 (20 pages)
- 932VS (37 pages)
- R3210-1 (26 pages)
- CM1450 (16 pages)
- R883 (4 pages)
- R3203-1 (24 pages)
- MS1290LZA (40 pages)
- AC99401 (16 pages)
- MS1065LZA (32 pages)
- R3210 (24 pages)
- TS3650 (76 pages)
- 932/932VS (2 pages)
- BS1400 (32 pages)
- R845 (24 pages)
- MS1290LZ1 (40 pages)
- AC9930 (12 pages)
- R8452 (24 pages)
- MaxSelect R885 (26 pages)
- AC99402 (16 pages)
- TS2400LS (39 pages)
- 122XL (39 pages)
- SP6263 (80 pages)
- TS 2400 (68 pages)
- MS1250LZ1 (34 pages)
- MS1250LZA (36 pages)
- BS14002 (36 pages)
- AC1030 (6 pages)
- R4121 (25 pages)
- TS3660 (56 pages)
- Table Saw (68 pages)
- R4516 (40 pages)
- MS1065LZ (30 pages)
- Dry Cut Saw (36 pages)
- AC9940 (16 pages)
- MS1290LZ (40 pages)
- R3200 (2 pages)
- R855 (24 pages)
- MS1250LZ (36 pages)
- R3202 (22 pages)
- AC9944 (8 pages)
- 530-2 Reciprocating Saw (21 pages)
- HC-300 (320 pages)