ROTEL RMB-1066 - Manual (Page 9)

9 English
Specifications
Continuous Power Output Stereo Mode 60 watts/ch into 8 ohms
(20-20 kHz, < 0.03% THD)
Continuous Power Output Bridged Mono Mode 150 watts/ch into 8 ohms
(20-20 kHz, < 0.1% THD)
Total Harmonic Distortion < 0.03%
(20Hz-20kHz, 8 ohms)
Intermodulation Distortion < 0.03%
(60 Hz : 7 kHz, 4:1)
Frequency Response ( ± 1 dB) 15Hz–100kHz
Damping Factor (20-20,000 Hz, 8 ohms) 150
Speaker Impedance (combined load)
Stereo mode: 4 ohms minimum
Bridged Mono mode: 8 ohms minimum
Signal to Noise Ratio (IHF A network) 116 dB
Input Impedance 22 k ohms
Input Sensitivity 1.5 volt
Auto Turn On Threshold Level (if activated) 10 mV input signal
Auto Turn Off Delay Time (if activated) 5 minutes with no signal
Power Requirements
USA: 115 Volts, 60 Hz
Europe: 230 Volts, 50 Hz
Power Consumption 700 Watts
Dimensions (W x H x D) 430 x 121 x 435 mm
16
15 / 16 x 4 3 / 4 x 17 1 / 8 in
Weight (net) 13.5 kg, 29.75 lb.
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.