Regency Freestanding and Fireplace Insert Pellet Stove GFI55 - Manual (Page 2)

March 2008 Product Specifi cations Book 8
Gas Inbuilt
P
ellet Sto
v
es & Inser
ts
GFI55 Wood Pellet Insert
CLEARANCES TO COMBUSTIBLES
FIREPLACE SPECIFICATIONS
Your fi replace opening requires the following minimum sizes:
Height 55 lbs hopper (standard)
42 lbs hopper (adjusted) 22.75" (578mm)
19.5" (495mm)
Width 26" (660mm)
Depth 15" (381mm)
EXHAUST AND FRESH AIR INTAKE LOCATION
EXHAUST:
Base of unit to center of fl ue 9-1/16" (229mm)
Side of unit to center of fl ue 6-1/8" (156mm)
Center of unit to center of fl ue 5-3/4" (146mm)
FRESH AIR INTAKE:
Base of unit to center of intake 3-7/16" (87mm)
Side of unit to center of intake 10-7/8" (277mm)
Center of unit to center of intake 1" (25mm)
INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENTING
MANUFACTURER.
1"
(25mm)
5 3 / 4 "
(146mm)
3 7 / 16 "
(87mm)
10 7 / 8 "
(277mm)
6 1 / 8 "
(156mm)
9 1 / 16 "
(229mm)
MASONRY FIREPLACE
INSERT INSTALLATION
Floor
Protection
Combustible Floor Masonry Fireplace
Min. 6"
Rain Cap
Steel Plate or Flashing
Mantel (8" deep)
Fresh-air intake
Clean-out tee
If holes already exist
fresh-air intake can
be taken through the
back of the fireplace
or through the ash
dump.
Damper Removed
or Fastened Open
Min. 8" from
top of stove
OUTSIDE FRESH AIR CONNECTION
Outside fresh air is mandatory when installing this unit in airtight
homes and mobile homes.
A Fresh-air intake is strongly recommended for all installations.
Failure to install intake air may result in improper combustion as well as
the unit smoking during power failures.
When connecting to an outside fresh air source, do not use plastic or
combustible pipe. A 2” minimum (51 mm) ID (inside diameter) steel,
aluminum or copper pipe should be used. It is recommended, when you
are installing a fresh air system, to keep the number of bends in the pipe
to a minimum.
2" ID
(51 mm)
Optional
Elbow
Outside
Wall
The fi replace insert is certifi ed to be installed into a masonry fi replace only
and/or zero clearance wood burning factory built fi replace where allowed
by local codes. This model includes a surround faceplate and a pedestal.
When installing this unit, ensure that the pedestal is removed from the
inside of the hopper and installed on the bottom of the unit.
From the body of the heater to the:
Side
Wall 8" (203mm) minimum
Facing on Masonry Fireplace: 8" (203mm) minimum
8” (203mm) mantle: 8" (203mm) minimum