RCA L32WD23 - Manual (Page 7)

Connections and Setup
Chapter 1 7
Mounting Your TV to the Wall
Caution: The wall mount must bear a minimum of fi ve times
the TV’s net weight without causing damage.
To mount your TV to the wall you need to purchase a VESA wall
mount.
For models L26WD22 and L26WD23, purchase a VESA 100 x 100,
M4 screw.
For models L32WD22 and L32WD23, purchase a VESA 200 x 200,
M6 screw.
For model L37WD23, purchase a VESA 400 x 400, M6 screw.
The VESA number is the horizontal and vertical measurement of
the mounting holes. For example, 100 x 100 means the mounting
measurements are 100mm horizontally and 100mm vertically.
1. If the base is attached, you need to remove it before attaching the
wall mount.
A. Place the TV facedown on a surface that is soft, yet strong
enough to hold the TV.
B. Use a screwdriver to remove the screws from the holes
as shown in the picture to the left. Models L26WD23 and
L32WD23 have seven screws; model L37WD23 has six screws.
The models with different numbers of screws are located
relatively in the same place as the picture shows.
Models L26WD22 and L32WD22 have four screws on the
bottom of the base as shown above in Attaching Your TV's
Base.
2. Make sure all cables are already connected to the TV.
3. Follow the directions included with the wall mount to mount the
TV to the wall.
Remove the screws that attach to the TV's
base attachment.
Attaching Your TV’s Base
Your TV comes shipped without the base attached so that you can
choose to mount your TV either to its base or to a wall (wall mount
sold separately). If you want to mount your TV to the wall, don’t
attach the base and instead follow the Mounting Your TV to the Wall
instructions below.
1. Locate the base. For models L26WD22 and L32WD22, locate the
four screws. For models L26WD23, L32WD23, and L37WD23,
locate the three screws.
2. Attach the screws to the bottom of the base as the pictures to the
left show.
For models L26WD23, L32WD23, and L37WD23, the screw holes
underneath the TV match with the screw holes inside the base.
Push down on the top of the TV until it clicks into the base.
For models L26WD22 and L32WD22, the two screws go into each
side of the base.
Bottom of base- models L26WD23, L32WD23,
and L37WD23
Bottom of base- models L26WD22
and L32WD22