Runco VX-6c - Manual (Page 50)

3.7 Adjusting System Parameters and Advanced Controls
Use the Installation, OSD Settings and Information menus to display and/or alter overall system
parameters rather than those that affect a specific source or channel.
Use the Advanced menu whenever you need to work with or replace the lamp, select a test pat-
tern, define a new color temperature, or access lesser-used image control settings intended for
experienced users.
Projector Configuration
Choose from Floor Front, Floor Rear, Ceiling Front, Ceiling Rear according to your installation.
If the setting is incorrect, the image will be reversed and/or upside down.
OSD Language
Choose from English, French, Spanish, German and Italian language. The menus will change
immediately upon selection.
OSD SETTINGS
Use OSD Settings checkboxes and pull-down lists
to alter how the projector responds to commands
and displays its parameters. Refer to the “Using
Slidebars and Other Controls” subsection if you
need help. Changes made to the OSD Settings
menu will be saved when you exit the menu.
OSD Position
Use the pull down list to choose the pre-defined or customized default location for the display
of on-screen menus. To create a custom menu location, choose a preset that is closest to the
desired area. Then adjust the sidebars of H Postion and V Position to move the menu to the
desired location. To prevent cropping of larger menus, avoid locations too close to a corner or
edge.
H Position / V Position
Shift your menus as desired, creating a customized menu location.
OSD Settings
OSD Position
H Position
V Position
Display M. Bank List
Show Adjust Bar
Show Messages
50
50
Variable
4:3 Upper/Left
4:3 In 1
4:3 In 2
16:9 Upper/Left
16:9 In 1
16:9 In 2
Variable
Variable
3-24
OSD Settings Menu
OPERATION