Radio Shack 2.4 GHz Digital Spread Spectrum Cordless Telephone with Call Waiting/Caller ID - Manual (Page 9)

9 Installation
STORING YOUR AREA
CODE
You can store your local area code in the
phone’s Caller ID record so it does not show
the area code if the received call is from your
local area.
Note: If your calling area requires 10-digit di-
aling including area code, do not enter the
area code but leave this option blank.
Follow these steps to store your area code.
1. Lift the handset and press MUTE/PGM .
7H;7ý9E:; 7H;7ý9E:; 7H;7ý9E:; 7H;7ý9E:;
appears.
2. Enter your three-digit area code.
3. Press MUTE/PGM twice to exit.
SETTING THE RINGER
LEVEL
You can select high or low ringer volume, or
turn the ringer off.
1. Lift the handset and press MUTE/PGM
twice.
H?D=ýB;L;B H?D=ýB;L;B H?D=ýB;L;B H?D=ýB;L;B
appears with the cursor
pointing to the current setting.
2. Press
6 6 6 6
/
∗∗∗∗
/TONE or #/
7 7 7 7
to move the
cursor to the desired setting (
>? >?>? >?
,
BE BE BE BE
, or
E<< E<< E<< E<<
).
3. Press MUTE/PGM .
Note: When you select
E<< E<< E<< E<<
,
H_d][hý E\\ H_d][hý E\\ H_d][hý E\\ H_d][hý E\\
appears and the phone beeps. You can
still make or receive a call. When you
have an incoming call, the phone con-
nected to the same line rings, and
H_d]# H_d]# H_d]# H_d]#
_d] _d] _d] _d]
appears (then Caller ID information,
if you subscribe to the service).
USING THE BELT CLIP
To attach the belt clip, align the clip with the
slots on the sides of the handset, then snap it
into place.
To remove the belt clip, use a flat object such
as a table knife to pry the belt clip off the
phone.