Rover 460 - Manual (Page 8)

7
OPERATION - All mowers
To Start the engine
Refer to the engine manufacturer owner’s manual for detailed starting procedure.
Ensure that the engine oil is at the correct level and that the fuel tank is full of fresh
unleaded petrol.
ƒ Move the throttle control lever to the :- “CHOKE”
position (where fitted) - or
the “FAST” position and prime the engine. Refer to the engine manufacturer’s
manual.
ƒ Grasp rope handle and pull slowly until resistance is felt. Then pull the cord
rapidly to overcome compression, prevent kickback and start engine. Repeat if
necessary.
ƒ If a “Choke” is fitted move the throttle control lever to the “FAST” position
after the engine starts.
To Stop the engine
Move the throttle control lever to the “STOP” position
Wait till the engine comes to a complete stop before removing or fitting the grass
catcher or mulch plug to the mower, or attempting any maintenance work on the
mower.
OPERATION - Self Propelled mowers only
Engaging the Drive
ƒ Start the engine and move the throttle to the “FAST”
position.
ƒ Push slowly on the clutch engagement lever to
engage the self-propelled drive to the rear wheels.
Refer to figure 14.
Disengaging the Drive
ƒ Release the clutch engagement lever.
ƒ Allow the clutch engagement lever to return to the
disengaged position.
Figure 14. Clutch
engagement lever
WARNING
To avoid excessive clutch wear.
Do not hold the engagement lever in a semi-engaged position.