Radio Shack 60-501 - Manual (Page 4)

4
b
Battery Notes:
• You can power your Flipz with two AAA alkaline batteries
instead of the Li-Po battery, but you may not have all the
stunt functions.
• Thoroughly check the charger and Li-Po battery before
charging.
• The Li-Po battery included in the package needs to be
charged before using for the first time. Remove the battery
after charging.
• Use only the Li-Po battery and charger included in the
package as it is specially designed to use for Flipz.
• Always charge the battery under adult supervision.
• Allow the Li-Po battery to cool down before recharging.
• Do not charge your battery under direct sunlight, heated,
humid places or inside a vehicle.
• Do not dismantle or solder the charger nor the battery.
• If your charger or Li-Po battery is extremely hot, smoking,
expands, smells or the green LED doesn’t blink, turn off
your charger and remove the battery.
• Use only fresh batteries of the required size and type. Do
not mix old and new batteries, different types of batteries
(standard, alkaline, or rechargeable), or rechargeable
batteries of different capacities.
• Dispose of batteries promptly and properly. Do not burn
or bury them. If you do not plan to use the vehicle for a
long time, remove the batteries from both the vehicle and
controller.
• If the electrolyte in the cells should get on your skin,
thoroughly wash with soap and water. If in the eyes, rinse
thoroughly with cool water. Immediately seek medical
attention.
• Follow the manufacturer’s instructions for charging the
battery and do not charge longer than recommended.