Reebok Fitness RL 525 RBCCEL79021 User Manual

Page 8

9. Apply a small amount of grease to the axle on the

left Crank Arm (40). Identify the Left Pedal Leg (28),

which is marked with a decal. Slide the Left Pedal

Leg onto the axle on the left Crank Arm (40). Slide a

Large M8 Washer (70) and a Wave Washer (101)

onto an M8 x 25mm Patch Screw (73), and tighten

the Patch Screw into the axle. Make sure that the

Wave Washer is on the axle before tightening the

Patch Screw.

Snap a Pedal Cushion (74) around the Left Pedal

Leg (28) onto a Cushion Bracket (99). Make sure that

the arrow on the Pedal Cushion is pointing to one of

the numbers on the Left Pedal Leg and that the num-

ber shows through the window in the Cushion

Bracket.

Assemble the Right Pedal Leg (not shown) in the

same way.

10. Identify the Left Pedal Arm (33), which is marked

with a decal. Attach the Left Pedal (35) to the Left

Pedal Arm with two M6 x 20mm Patch Screws (75)

as shown.

Attach the Right Pedal (not shown) to the Right

Pedal Arm (not shown) in the same way.

Grease

101

Window

8. Insert the Pivot Axle (21) into the Upright (2), and

center the Pivot Axle. Apply a small amount of the

included grease to both ends of the Pivot Axle.

Identify the Left Upper Body Arm (5), which is

marked with a decal. Insert an Upright Bushing (20)

into an Upright Spacer (19). Turn the Upright

Spacer so that the semicircular cutout is at the top,

and slide the Upright Spacer onto the post on the

Left Upper Body Arm.

Slide the Left Upper Body Arm (5) onto the Pivot

Axle (21). Attach a Pivot Spacer (17) to the Left

Upper Body Arm with an M4 x 16mm Screw (82).

Turn a Pivot Endcap (16) so that the rectangular

cutout is at the bottom. Using a rubber mallet, tap

the Pivot Endcap into the Pivot Spacer.

Slide a Small M8 Washer (71) onto an M8 x 19mm

Shoulder Screw (102), and tighten the Patch Screw

into the Pivot Axle (21).

Attach the Right Upper Body Arm (6) in the

same way.

102

Grease

Post