RCA 25205 - Manual (Page 66)

1
Flash Time
Depending on the services you have with the phone company, you may need to adjust the
flash timing. It can be set to 100ms or 600ms. The default is 600ms.
1. Press the MENU button.
2. Use the 5 or 6 to scroll to PHONE SETTING.
3. Press Sel/Save.
4. Use the 5 or 6 to scroll to FLASH TIME.
5. Press Sel/Save.
6. Use the 5 or 6 to scroll to the desired setting.
7. Press Sel/Save to save. To start over, press EXIT to return to the PHONE SETTING menu.
New Call Indicator
1. Press the MENU button.
2. Use the 5 or 6 button to scroll to PHONE SETTING.
3. Press Sel/Save.
4. Use the 5 or 6 button to scroll to NEW CALL LED.
5. Press Sel/Save.
6. Use the 5 or 6 button to select on or off.
NOTE: If you select ON, the New Call Indicator will flash after the phone receives a new caller ID. If it is
OFF, the New Call Indicator will stay at OFF status even if a new caller ID is received.
7. Press Sel/Save to save. To start over, press EXIT to return to the PHONE SETTING menu.
Out-Going Announcement Introduction
There are many OGAs for each line and for different purposes.
DEFAULT:
The pre-recorded message “Please leave a message after the tone” is
an invite for the caller to leave message.
PERSONAL: It is empty when powered up for the first time. You have to record it
if you don’t want to use the DEFAULT OGA.
Connections and Setup