Remington BV12199A User Manual
Page 9
REMINGTON® ELECTRIC BLOWER/VAC |
5
Follow the steps below to convert from
blower to vacuum. IMPORTANT: You must
install the collection bag/adaptor before
installing the vacuum tube assembly. The
vacuum tube assembly hooks into the
collection bag/adaptor. The vacuum will
not run unless the vacuum tube assembly
is locked into place.
1. Press locking lever on bottom inlet
cover and remove bottom inlet cover
from blower/vac. Remove blower tube
from blower/vac.
2. Insert vacuum tube adaptor into
opening in vacuum bag (see Figure
3-5). Move bag collar beyond the
plastic rib of the vacuum tube adaptor
(see Figure 3-6). Tighten and secure
bag collar to adaptor using the hook
and loop strap (see Figure 3-7).
3. Slide vacuum tube adaptor onto outlet
on front of blower/vac housing (see
Figure 3-8). Make sure the adaptor
locks into place.
Figure 3-5: Inserting vacuum tube adaptor
into vacuum bag
Figure 3-6: Positioning vacuum bag collar
Figure 3-7: Tightening vacuum bag collar
Figure 3-8: Sliding vacuum tube adaptor into place
Converting from
Blower to Vacuum
WARNING: To Reduce The
Risk of Personal Injury or Electric
Shock – Disconnect from power
source before assembling or
changing attachments.
118034