Remington BV12199A - Manual (Page 8)

4 |
3 blower/vac assembly
Assembling Blower
Follow the steps below to assemble the
blower. IMPORTANT: You must install the
blower tube before installing the bottom
inlet cover. The bottom inlet cover hooks
onto the blower tube. The blower will not
run unless the bottom inlet cover is locked
into place.
1. Slide the blower tube onto outlet
on front of blower/vac housing (see
Figure 3-1). Make sure the moulded
hook on the blower tube is positioned
below the blower.
2. Position front of bottom inlet cover
over blower tube hook (see Figure
3-2).
3. Pivot bottom inlet cover to bottom
of blower/vac housing. Slightly press
locking lever on bottom inlet cover
to allow cover to lock into place (see
Figures 3-3 and 3-4).
Figure 3-4: Pressing locking lever
WARNING: To Reduce The
Risk of Personal Injury or Electric
Shock – Disconnect from power
source before assembling or
changing attachments.
Figure 3-1: Sliding blower tube into place
Figure 3-2: Attaching bottom inlet cover to
blower tube hook
Figure 3-3: Pivoting bottom inlet cover to
blower/vac housing
118034
1
2
3
4