Ricoh Rioch 5 Mega Pixel CCD Monochrome PoCL Camera Link Camera FV-L500B1 User Manual

Page 26

26/31

FV-L500B1
User’s Guide Rev. 1.02

4.4.2

Descriptions of the Camera Control Commands

(The underline settings are the factory default settings)

Command No.

Command Descriptions

10H:

MOD1[7

[Camera function mode setting 1] Initial data: 09H

This sets the following camera function mode.

D[7

D7:

Continuous / Trigger Mode

0: Auto

1: Manual

D6:

Trigger Polarity

0: Positive

1: Negative

D5:

Trigger Mode

0: Edge Preset

1: Pulse Width

D4:

Binning Mode

0: OFF (Normal)

1: ON (Binning)

D3:

Scanning Mode

0: Full scanning

1: Partial scanning

D2~D0:

Reset Mode

000: Non-Reset

001: V-Reset

010~111: No function

(Prohibited setting. Please do not use these)

When D7 is set to “0: Auto”, a camera will detect its operational mode based on the input trigger signal.

If the input trigger signal is kept at high, the camera operates in the continuous mode, assuming the trigger polarity

is set to positive.

11H:

MOD2[7

[Camera function mode setting 2] Initial data: 0

This sets the following camera function modes.

D[7

D7~D4:

No Function

Set always “0000”

Function Mode

0: Trigger

1: Normal

D2~D0:

Partial Scanning

000: Full scanning

001: 1/2 partial scanning

010: 1/4 partial scanning

011~110: No function

(Prohibited setting. Do not set these values)

111: Variable partial scanning

Function mode is enabled when the “Continuous/Trigger” mode selection (MOD[7] is manual (set as 1).

No video output without the trigger signal input while the camera works with the trigger mode.

12H:

MOD3[7

[Camera function mode setting

3] Initial data: 0

This sets the following camera function modes.

D[7

D7~D6: Video Out

00: 10bit

01: 8bit

10: 12bit

11: No function (Prohibited setting. Do not set these values)

D5:

Trigger-in connector selection

0: Camera Link (CC1)

1: /IO connector (No.2 Pin)

D4~D3: Exposure Start Mode

00: Normal

01: Reserved trigger

10 ~11: H reset

D2~D0: No Function

Set always “000”