RIDGID R84040 - Manual (Page 12)

12 13
OPERATION
INSTALLING BATTERY PACK
See Figure 4.
n
While holding the caulk gun pointed away from you, lock
the switch trigger by sliding the switch lock to the left.
Place the battery pack on the tool. Make sure the latches
on each side of the battery pack snap into place and
the battery pack is secured on the tool before beginning
operation.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the drill
and latches into place properly. Improper installation
of the battery pack can cause damage to internal
components.
REMOVING THE BATTERY PACK
See Figure 4.
�n Lock the switch trigger by sliding the switch lock to the
left.
�n Depress the latches on the side of battery pack.
�n Remove the battery pack from the tool.
STARTING/STOPPING THE CAULK GUN
See Figure 5.
Before attempting to start the caulk gun, be sure the switch
lock is in the unlocked position.
�n To turn the caulk gun
ON, depress the switch trigger.
�n To turn the caulk gun OFF, release the switch trigger.
LOCKING THE SWITCH TRIGGER
See Figure 5.
The switch trigger of the caulk gun can be locked off using
the slide switch located above the switch trigger.
�n To lock the switch trigger, slide the switch lock left. This
will prevent the caulk gun switch trigger from being de-
pressed.
�n To unlock the switch trigger, slide the switch right. This
will allow the caulk gun switch trigger to be depressed.
Fig. 4
Fig. 5
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK
BATTERY PACK
ON
OFF
SWITCH
TRIGGER
LOCK
SWITCH
LOCK
UNLOCK