Radio Shack TAD-1005 User Manual

Page 14

• If the TAD answers when the

memory is full, it plays the mem-
ory full announcement and beeps,
waits 7 seconds for any remote
operation commands (see “Using
Remote Operation Commands”),
then hangs up. The TAD cannot
record additional messages until
you delete some of the old ones
(see “Saving/Deleting Mes-
sages”).

Using the Mailbox Feature

The TAD is preset to record calls for a
single user; however, the mailbox fea-
ture allows you to set up four separate,
private mailboxes in addition to the
general message mailbox. Callers can
leave messages in mailboxes for spe-
cific individuals or departments or gen-
eral messages for everyone to hear.

Follow these steps to turn on the mail-
box feature.

1. Press

PGM/DEL

. The answer indi-

cator flashes.

2. Press

ANNOUNCE

3. Press

. The TAD beeps twice

and is set for mailbox operation.

Note: If you have not recorded an out-
going announcement, the TAD says
“Press OGM to record a new outgoing
message for mailbox.” The answer in-
dicator stops flashing and the TAD
beeps twice.

When the mailbox feature is turned on,
after the TAD answers a call, the out-
going announcement plays and the
TAD sounds a beep. Within 2 seconds,
the caller must enter the desired mail-
box number. If no mailbox number is
entered, the TAD records the message
in the general message area.

Turning the Mailbox Off

Follow these steps to turn off the mail-
box and record calls for a single user.