Radio Shack TAD-1005 User Manual
Page 12
12
Recording the Memory Full
Announcement
The TAD has a built-in memory full an-
nouncement. When the memory be-
comes full and the TAD can no longer
record messages, the TAD announces
“The memory is full.”
Follow these steps if you want to
record your own memory full an-
nouncement.
Note:
The maximum recording time for
the memory full announcement is pre-
set to 1 minute, but you can change it
to 3 minutes (see “Setting the Mes-
sage Length”).
1. Press and hold
OGM
and
1M/3M
at
the same time until the answer
indicator flashes.
2. Speak into the TAD in a strong
voice from about 12 inches away.
3. Press
ON/OFF
when you finish
recording the announcement. The
TAD plays the current memory full
announcement.
Checking the Memory Full
Announcement
To listen to your own memory full an-
nouncement, press
OGM
, then press
1M/3M
immediately.
If you want to stop listening to the
memory full announcement before it
ends, press
ON/OFF
. The TAD beeps
three times.
43-745.fm Page 12 Friday, August 13, 1999 2:16 PM