Using the s8 lightweight ii, Set up the s8 lightweight ii – ResMed Positive Airway Pressure Device S8 User Manual
Page 5
3
Using the S8 Lightweight II
Using the S8 Lightweight II
!
WARNING
•
Make sure the power cord and plug are in good condition and the
equipment is not damaged.
•
Only ResMed air tubing should be used with the device. A different type
of air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
•
Blocking the hose and/or air inlet of the device while in operation could
lead to overheating of the device.
!
CAUTION
•
Be careful not to place the device where it can be bumped or where
someone is likely to trip over the power cord.
•
If you put the device on the floor, make sure the area is free from dust
and clear of bedding, clothes or other objects that could block the air
inlet.
•
Make sure the area around the device is dry and clean.
Set Up the S8 Lightweight II
1
Connect the power cord to the socket at the rear of the S8 Lightweight II.
2
Plug the other end of the power cord into the power outlet.
3
Connect one end of the air tubing firmly onto the air outlet.
4
Connect the assembled mask system to the free end of air tubing.
For information on assembling your mask, see your mask manual.
1
2
3
4