ResMed Positive Airway Pressure Device S8 - Manual (Page 14)

12
Insufficient air delivered from S8 Lightweight II
The following message is displayed on the LCD after you try to update settings
or copy data to the Data Card: Card Error Remove Card
The following message is displayed on the LCD after you try to update settings
or copy data to the Data Card: Settings Invalid Remove Card
The following message is displayed on the LCD after you try to update settings
or copy data to the Data Card: Settings Error Remove Card
The following message is NOT displayed on the LCD after you try to update the
settings using the Data Card: Settings Success Remove Card
Ramp Time is in use. Wait for air pressure to build up or change ramp time.
Air filter is dirty. Replace air filter.
Air tubing is kinked or
punctured. Straighten or replace tubing.
Air tubing is not connected
properly. Check air tubing.
Mask and headgear are not
positioned correctly. Adjust position of mask and headgear.
Cap(s) are missing from
access port on mask. Replace cap(s).
Pressure required for
treatment may have changed. See your clinician to adjust the pressure.
Data Card is not inserted
correctly. Check that you are inserting the Data Card into the Data
Card slot with
the arrow facing up, while the S8
Lightweight II is switched on and not delivering therapy
(standby mode).
The Data Card is only partly
inserted. Ensure that the Data Card is inserted into the Data Card
slot as far as it will go.
You may have removed the
Data Card before settings
were copied to the
S8 Lightweight II. Reinsert the Data Card and wait for the Settings
Success Remove Card message to appear on the
LCD.
The card is not a ResScan Data
Card. Only use a ResScan Data Card.
The identification details on
the Data Card do not match
the identification details on
your device. Contact your clinician immediately.
There is a data error on the
Data Card. Contact your clinician immediately.
The settings were not
updated. Contact your clinician immediately.