Radio Shack 43-1122 - Manual (Page 12)

12 Operation
ADJUSTING THE
HANDSET’S VOLUME
To adjust the volume of the sound you hear
through the handset during a call, press
8 8 8 8
or
9 9 9 9
on the handset until you obtain the
desired volume level.
Lebkc[ Lebkc[ Lebkc[ Lebkc[ CWn_ckc CWn_ckc CWn_ckc CWn_ckc
,
Lebkc[ Lebkc[ Lebkc[ Lebkc[ >_]^ >_]^ >_]^ >_]^
,
Lebkc[ Lebkc[ Lebkc[ Lebkc[ C[Z_kc C[Z_kc C[Z_kc C[Z_kc
, or
Lebkc[ Lebkc[ Lebkc[ Lebkc[ Bem Bem Bem Bem
appears on the handset display. Once you
set the volume level, the setting is
maintained even after you hang up the
phone.
Note: When you press
8 8 8 8
while the volume
is maximum or
9 9 9 9
while the volume is low,
the setting does not change. The phone
sounds three short beeps.
USING REDIAL
You can quickly dial the last number you
dialed. Lift the handset and press
REDIAL/
PAUSE , then TALK . The phone dials the
number.
Notes:
• You can also press REDIAL/PAUSE after
pressing TALK .
• The redial memory holds up to 32 digits,
so you can redial long-distance as well
as local numbers.
• The redial memory also holds pause
entries (see “Entering a Pause” on
Page 14).
USING FLASH
FLASH performs the electronic equivalent of
a switchhook operation for special services,
such as Call Waiting. For example, if you
have Call Waiting, press
FLASH to answer an
incoming call without disconnecting the
current call. Press
FLASH again to return to
the first call.
Note: If you do not have any special phone
services, pressing
FLASH might disconnect
the current call.
USING TONE SERVICES ON
A PULSE LINE
Some special services require tone signals
(such as bank-by-phone). If you have pulse
dialing, you can still use these special tone
services.
Dial the service’s main number. When the
service answers, press
∗
/TONE/
6 6 6 6
. Any
additional numbers you dial are sent as tone
signals.
The phone’s dial mode resets to pulse when
you make or receive a call.
PAGING
To send a page from the base to the handset
or to locate the handset when the phone is
not in use, press
PAGE/FIND on the base.
The handset beeps for about 1 minute.
FW]_d] FW]_d] FW]_d] FW]_d]
appears on the handset while the
page sounds.
To stop the page, press any key on the
handset, place the handset on the base, or
press
PAGE/FIND on the base again.
Note: The phone rings when a call comes in
while you are using the page feature.
USING A HEADSET
You can make or answer calls with hands-
free convenience using an optional headset
that has a
3 / 32 -inch (2.5-mm) plug. Your local
RadioShack store has a variety of headsets
available.
To connect the headset, gently flip open the
rubber headset jack cover on the side of the
handset, then insert the headset’s plug into
the jack.