Device connection – Rosewill RC200 User Manual
Page 5
ULTRA ATA/133 PCI RAID Card
RC200 User Manual
5
Note: For proper operation of the Ultra ATA 133 PCI RAID card, the jumper
must remain on.
1.
Turn Off the power to your computer and any other connected peripheral devices.
2.
Unplug the power cord from the back of the computer.
3.
Remove your computer’s cover.
4.
Remove the slot bracket from an available PCI slot.
5.
To install the card, carefully align the card’s bus connector with the selected PCI slot
on the motherboard. Push the board down firmly, but gently, until it is well seated.
6.
Replace the slot bracket’s holding screw to secure the card.
Device Connection
The UltraATA 133 RAID PCI is a dual channel Ultra ATA/133 controller that support up
to for IDE hard disk drives. To achieve maximum performance and compatibility we
suggest using identical hard drives in building your RAID sets.
- RC-702 (6 pages)
- RNX-G300 (20 pages)
- RC304-E (5 pages)
- RNX-N300 (4 pages)
- PCIe LAN Card RC-401-Dual-EX (8 pages)
- RC216 (13 pages)
- RC214 (4 pages)
- RX-35MV (5 pages)
- WIRELESS N ADAPTER RNX-N250PC (14 pages)
- RNX-G400 (55 pages)
- PCIe FireWire 1394a Card 2+1 Port RC504 (4 pages)
- RC212 (24 pages)
- RNX-N180PCE (11 pages)
- RC-301E (5 pages)
- RNX-N150PCX (46 pages)
- RC-110 (7 pages)
- RCW604 (5 pages)
- RX251-US (15 pages)
- RC-301 (5 pages)
- RX-DU100 (5 pages)
- RC-304 (5 pages)
- RX343-S BLK/SLV (2 pages)
- RC-100 (8 pages)
- SATA+Ultra ATA Raid Controller RC212 (6 pages)
- RC-400 (6 pages)
- RC-209-EX (24 pages)
- RC-600 (10 pages)
- RNX-N250UB (73 pages)
- RC218 (9 pages)
- RNX-N150RT (8 pages)
- RC-302 (5 pages)
- RNX-MININ1 (12 pages)
- G03-ATI9000 (33 pages)
- RNX-N100 (8 pages)
- RX25-AT-SC-BLK/SLV (5 pages)
- RNX-G300EXLX (111 pages)
- RNX-N4PS (6 pages)
- RX81U-MP-25A-S/B (4 pages)
- RNX-56CX (24 pages)
- RNX-N250PC (46 pages)
- RNX-G100 (7 pages)
- RNX-N180UBE (9 pages)
- RC401-EX (4 pages)
- RNX-N2LX (32 pages)