Rosewill RC200 - Manual (Page 22)

ULTRA ATA/133 PCI RAID Card RC200 User Manual
22
7. D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive
you are using. If D is not letter of your CD-ROM drive, substitute D with the correct
drive letter), then click Next.
8. Click Next again, then Finish.
9.
Restart Windows to complete driver installation.
＊ For Existing Windows® 98SE Installation
1. Setup the RAID Array prior to driver installation.
2. Install the board and boot up Windows® 98SE.
3. At the Add New Hardware Wizard, click Next.
4. Select Search for the best driver for your device and click Next.
5. Insert the driver CD into the CD-ROM Drive and click Next.
6. Select Search for the best driver for your device(Recommended) from the following
dialog box and type
7. D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive
you are using. If D is not letter of your CD-ROM drive, substitute D with the correct
drive letter), then click Next.
8. Click Next again, then Finish.
9. Restart Windows to complete driver installation.
For Windows® ME
＊ For New Windows® ME Installation
1. Setup the RAID Array prior to Windows installation.
2. Install the board and follow Microsoft procedures to install Windows® ME accordingly.