Roland PNC-900 - Manual (Page 8)

2
1 PRECAUTIONS
• When Moving the PNC-900...
Do not try to pick up or move the PNC-900 by grasping the top area of the unit -- be sure to use both hands to grip the PNC-
900 securely on the left and right sides.
• Precautions Regarding Placement
• When choosing a place to set up the PNC-900, make sure you have a space that is at least 488 mm (19-1/4") wide, 290 mm
(11-7/16") in depth, and 217 mm (8-9/16") in height.
• Since the sheet moves during cutting, make sure the unit is placed on a stable, sturdy surface. Also make sure there is nothing
that can block the sheet at both front and rear.
• Never leave the unit in a place that is subject to high levels of humidity.
• Never leave the unit in a place that is subject to direct sunlight, or where the temperature could go to extremes.
• Never leave the unit in a place that is excessively dusty.
• Since it is normal for this device to emit heat when in operation, never place it where it is poorly ventilated and such heat
cannot dissipate.
• Precautions in use
• To prevent injuries, be very careful when handling the blades.
• Use the rated power voltage within
±
10%.
• When turning the power to the unit off and then on again, wait at least 10 seconds after switching the power off before
switching it back on.
• Always be careful whenever the unit is operated so as not to risk getting fingers or hair caught in its mechanisms.
• The power cord should always be handled with due care. Do not place heavy objects upon it.
• Under no circumstances should you attempt to disassemble the unit.
• When the unit is not in use, keep the pinch rollers raised. Also, pull out the power cord plug from the receptacle.
• Never move the tool carriage by hand.
• Never allow any liquids, metallic objects, or flammable material to get inside the unit.
• Never allow any strong shock to be applied to this unit.
• Do not place heavy objects on top of the unit.
2 CHECKING SUPPLIED ITEMS
Check the following to make sure that you received all the items that were shipped along with the unit.
Power Cord: 1 Blade for Sheet (Carbide): 1 Blade Holder: 1
Test-use Sheet: 2 Test-use Application Sheet: 1 Test-use Water-based Fiber-tipped
Pen: 1
User's Manual: 1