Radio Shack ET-1104 - Manual (Page 13)

13
OPERATION
MAKING AND RECEIVING
CALLS
To make a call, lift the handset and
press
TALK . The TALK indicator on the
handset and the IN USE indicator on the
base light. When you hear a dial tone,
dial the number.
To answer a call, simply lift the handset
from the base. If the handset is away
from the base, you can press any key to
answer a call.
The ET-1104 scans 20 channels (fre-
quency pairs used between the base
and the handset) and automatically se-
lects a clear channel each time you
make or receive a call.
Note: If the handset is too far from the
base, the channel might not be clear.
Move closer to the base and try making
the call again.
To end a call, place the handset on the
base or press
TALK .
Note: If you press TALK to hang up and
the phone does not disconnect, press
TALK again while holding the handset
closer to the base, or place the handset
on the base.
SETTING THE HANDSET
VOLUME
You can choose one of four volume set-
tings for the handset. To change the vol-
ume, press
VOL s or t during a call.
USING REDIAL
You can quickly dial the last number di-
aled. When you hear a dial tone, simply
press
REDIAL.
Notes:
• The redial memory holds up to 32
digits, so you can redial long-
distance as well as local numbers.
• The redial memory also holds pause
entries. See “Entering a Pause” on
Page 16.
• The redial memory does not store a
flash entry or any digits you press
after
FLASH (see “Using Flash” on
Page 14).
43-1104.fm Page 13 Wednesday, August 18, 1999 8:05 AM