RCA SCT-560 User Manual
Page 9
9
SPECIAL FEATURES
USING RELAY PLAY
You can load two cassette tapes to play one after the other.
Notes:
• The cassettes you load should have the same
Dolby NR type.
• You can start relay play from either Deck 1 or Deck 2.
• You can replace the tape in the idle deck during
relay play.
• When a tape automatically begins playing during
relay play, it always starts from the forward (
3)
playback side. Be sure to set the tapes properly
before starting relay play.
• If the deck encounters an unrecorded portion of
tape more than 15 seconds long, it fast forwards
the tape until it finds another recorded portion,
and resumes playback from that point (i.e., blank
skip is automatically set).
1. Load a cassette tape in each tape
compartment, then close the compartment
doors.
2. Set
DOLBY NR
for the noise-reduction system
you want to use. See “Dolby Noise Reduction”
on Page 7.
3. Set
REV MODE
to
RELAY/SKIP
.
4. Press or on Deck 1 or 2. Playback starts. See
“Playback Sequence.”
5. Adjust the volume, tone, and balance control
on your receiver/amplifier for the desired
sound.
6. To stop relay play before it automatically stops,
press
STOP
(
7) on the deck that is playing
any time during playback.
Playback Sequence
The cassette deck repeats the following sequence 8 times
(up to 32 sides).
Where playback starts in the sequence depends on which
play button you press first:
I. Side facing out, Deck 1
II. Side facing in, Deck 1
III. Side facing out, Deck 2
IV. Side facing in, Deck 2
• When you press 3 on Deck 1, playback starts at I.
• When you press 2 on Deck 1, playback starts at II.
• When you press 3 on Deck 2, playback starts at III.
• When you press 2 on Deck 2, playback starts at IV.
REWIND AUTO PLAY
To have Deck 1 rewind the cassette to the beginning of the
current side and start play, press
REWIND AUTO PLAY
.
Note: If both decks have tapes loaded, the decks operate
as described under “Using Relay Play.”
DEMO MODE
The cassette deck has a demonstration mode that
alternately turns on various indicators and meters so you
can see where they show on the deck.
To turn on the demonstration mode, press
TIME/COUNTER
and
RESET
on Deck 2 at the same time while the cassette
deck is stopped. To cancel the mode, press any button
except
EJECT
(
0) and
POWER
.
PRB1200A.En.01.13.DOC
9/2/99, 9:18 PM
9