Power off – Roku Music Player User Manual
Page 43
42
SECTION 8: WHEN YOU ARE FINISHED USING SOUNDBRIDGE
When you are finished playing music and using your SoundBridge altogether, just press the
Standby [
Ѷ] button on your remote. In Standby mode, SoundBridge can display the date and
time or a blank display, depending on your preference. (See page 40 for more information
about setting these preferences.)
If you were playing Internet radio when you pressed Standby, then pressing Standby again will
resume playback of that station. Otherwise it will return you to the music library to which you
were most recently connected.
If you plan to disconnect SoundBridge from AC power after you are done using it, be sure to
press the Standby button first. This logs you out of the music server software running on your
computer.
Note: Wait approximately 10 seconds after pressing Standby [
Ѷ] before unplugging
SoundBridge; this gives SoundBridge time to flush its settings for a clean reboot.
Hint: If you unplug the SoundBridge from AC power five times without pressing
Standby [
Ѷ] on your remote first, iTunes may lock you out of connecting to the server.
That’s because iTunes allows a maximum of five users to connect at one time, and if
you don’t put SoundBridge into standby mode first, iTunes may believe you are still
connected. To restore your access to the iTunes server, close iTunes and then restart it.
You should then have no trouble connecting to the iTunes server as before.
Section 8: When You Are Finished Using Soundbridge