Renesas Single-Chip Microcomputer SH7203 - Manual (Page 10)

WOW-SH7203 µClinux
8
D008290_11 Issue 1
User’s Manual
Setting the board initialisation script
1. Select the “Debug Settings” menu option from the “Debug” menu.
2. Add the binary files that are available for downloading to the board, to the target download section. In the Download
Module Dialog, the Format should be set to “Binary” and the Access Size should be set to 2.
• The Linux binary should be written at address offset 0x00000000 – This is the base address of the flash memory.
• The File system binary should be written at address 0x00200000 (0+2MB) – This is the next MB boundary after the
Linux kernel.
3. Finally under the options tab it is necessary to add a batch file operation to run before download of modules. This batch
file is required to set up the board initially for access by the FMtool when flashing.